COX CXO300 - Maneuvering the Vessel with; Single & Dual Installations; Troll Mode

5.0 OPERATION 49
CXO300 OWNER’S MANUAL
5.8.1 TROLL MODE
The control levers feature a troll mode which allows finer control of powerhead speed, intended for low
speed Manoeuvring.
Engaging this mode will map the movement of the control lever to a limited range of powerhead speed,
so that full lever demand ahead will only command 2000 rpm.
Engaging troll mode will not affect the powerhead speed response to lever movement in reverse.
 NOTE
All control levers must be in the neutral position to activate or deactivate troll mode.
5.9 MANEUVERING THE VESSEL WITH SINGLE AND DUAL INSTALLATIONS
 Figure: Using multiple outboards to steer the vessel without turning the wheel
While stationary, you may vary the control lever positions of the outboards in a multiple install to more
effectively maneuver your vessel through narrow corridors or in marinas.
Shifting one outboard into forward and the other into reverse can be used to turn the vessel in a tight
space.
Shifting both outboards into forward or reverse and then using different speed demands on the levers
can be used to steer the vessel without turning the outboards.