COX CXO300 - Changing Powerhead Oil Filter

6.0 MAINTENANCE 65
CXO300 OWNER’S MANUAL
 NOTE
Tighten the powerhead oil drain plug to 20 Nm (14.8 lb-ft).
11 Remove the CCV oil separator lid by depressing the yellow retaining tab and unscrewing the
lid counterclockwise by hand.
12 Fit a funnel or oil transfer pump hose securely to the mouth of the dipstick tube.
13 Fill the powerhead through the dipstick tube with a volume of fresh oil equal to the volume
removed, or 10.5 L, whichever is less. Confirm there are no leaks from the oil drain plugs
while filling.
 NOTE
Using oil outside of the recommended specification can lead to increased wear and reduced
durability and may void your warranty.
14 Allow 5 minutes for the oil to settle, then remove the funnel or transfer pump hose and use the
dipstick to check the oil level as described in section 6.4.2. Top up through the CCV oil
separator as necessary until the oil level is acceptable.
15 Once satisfied that the oil level is acceptable per section 6.4.2, fully insert and secure the
dipstick and refit the CCV separator lid clockwise by hand. Wipe clean any oil residue in the
work area then refit the two lower cowlings and tighten the joining fasteners.