5.0 OPERATION
5.0 OPERATION
42
CXO300 OWNER’S MANUAL
5.3.3 POST START CHECKS
After starting your outboard(s) and prior to heading out, check for any fuel leaks between tank and
outboard(s) and check that all fuel hoses are intact, securely attached and clamped.
Check the helm display for warning alarms and visually inspect the outboard(s) and rigging for normal
operation. Check that the control panel LED is lit green to indicate MOB protection is active and your
master fob is linked. Refer to section 5.2.1 for instructions on activating MOB protection if it is inactive.
Cooling water tell-tale streams must be visible from the front of each outboard. If tell-tale streams are not
visible within 30 seconds of starting your outboard(s), there may be a blockage or other cooling system
issue. Operating in this state could cause the outboard(s) to overheat and the control system to take
protective measures, including limiting performance or shutting down.
CAUTION
Do not operate your outboard(s) or leave port if tell-tale streams are not clearly visible.
5.3.2 KEYLESS IDENTIFICATION
Your wireless fob provides identification so that PIN entry into the control panel is not required.
Pressing any button on the fob will activate identification for 15 minutes and arriving at your boat
during this time will automatically unlock the control panel.
When ignition is turned off, the control panel will remain unlocked for 2 hours as long as a paired
wireless fob is within range. If you move out of range during this time, the control panel will lock but
fob identification will remain active for 15 minutes, unlocking the panel automatically if you move
within range again.
To Next Page
Loading...
