5.0 OPERATION 41
CXO300 OWNER’S MANUAL
NOTE
To restart an individual outboard
when ignition is already on,
return the throttle lever(s) to the
neutral position then press and
hold the corresponding arrow key
on the control panel.
WARNING
MOB protection will not be active after starting the
outboard(s) using the control panel. The control panel LED
may flash yellow and the panel may beep to indicate MOB
protection is inactive. Press and release the Stop/Start
button on a master fob to activate MOB protection after
starting. The LED on the control panel will light green to
indicate that MOB protection is active.
Figure: Starting a single outboard using a master fob
1 Carry out all pre-start checks in section 5.2.
2 Turn your battery switch to the ON position.
3 Place the throttle lever into the neutral
position.
4 Check your vessel and surroundings for any
hazards, clear any personnel in the vicinity of
your outboard, then tilt your outboard into the
water until nominally at zero trim.
5 Press and release the ON/OFF button (5)
on a paired master fob. The LED on the fob
will flash green 5 times quickly to indicate
ignition is on. The control panel’s LED will also
light yellow to indicate ignition is on.
6 Check for any warning alarms or notifications
on the helm screen and action accordingly.
7 Ensure the fuel system is primed by running
the fuel lift pump for at least 10 seconds prior
to starting your outboard, or longer if one or
more fuel filters or lines have been changed
or connected since the last start.
8 Press and hold the Start button (8) to send a
start signal to the outboard.
9 After starting the outboard, check that the
control panel LED (9) is solid green, indicating
that MOB protection functionality is active.
To start your single outboard using a master fob:
ON/OFF
START
8
5
9
START
ON/OFF
To Next Page
Loading...
