6.0 MAINTENANCE 75
CXO300 OWNER’S MANUAL
6.4.13 INSPECTING A BATTERY
Your outboard(s) requires stable battery power to function properly and regular checks and maintenance
are important in ensuring the ongoing good condition of your battery. Poor maintenance will accelerate
battery deterioration. Refer to the battery manufacturer for detailed maintenance instructions.
Regular checks include the following:
1 Visual inspection for tightness of the battery terminal connectors onto the battery posts. Tighten as
necessary with the appropriate tools for the installed connectors.
2 Visual inspection for corrosion on or around the battery terminals for battery terminal grease.
3 Visual inspection for any fluid leaks from the battery. Confirm that any leaks are from the battery itself
and not another nearby source. Top up or replace the battery as appropriate.
4 Voltage check on your helm screen with ignition on but your outboard(s) off. This voltage must
read at least 12V.
5 Voltage check with your outboard(s) running at idle. This voltage must read between 14 and 15 V.
Contact an authorized Cox Powertrain dealer if in doubt about the results of any of the regular checks.
WARNING
Battery posts, terminals and related accessories contain lead and lead compounds.
Wash hands after handling.
Do not allow flames, sparks or lighted substances near the battery. When working with batteries,
make sure there is sufficient ventilation and that appropriate personal protective equipment is
worn.
Keep batteries out of reach of children.
Batteries contain Sulphuric acid. Avoid contact with skin, eyes or clothing.
If exposed or concerned, flush immediately with water for a minimum of 15 min and
get medical advice/attention.
It is illegal to pollute drains, water courses, the sea or soils.
Dispose of any used battery in authorized waste facilities.
CAUTION
Do not reverse the battery cables. This may damage all electrical parts connected to the circuit.
To Next Page
Loading...
