COX CXO300 - Page 64

6.0 MAINTENANCE
6.0 MAINTENANCE
64
CXO300 OWNER’S MANUAL
8 Remove and replace the oil filter following the procedure in section 6.4.6.
9 Once the used oil has completed draining, remove the second oil drain plug on the opposing side of
the outboard, wipe the magnet clean of any metal savings and replace the plug. Have a rag ready for
any oil seepage.
10 Refit and tighten both oil drain plugs, ensuring both seals are in place.
 NOTE
The oil drain plugs seals must be replaced and the plugs tightened according to specification. Not
doing so can lead to oil leaks to the environment and significant damage or failure of your powerhead.
 NOTE
If there is significant build-up of metal shavings on either oil drain plug, take a photo and contact an
authorized Cox Powertrain dealer for further advice.
 WARNING
Engine oil and related components may be hot and can cause severe burns.
Avoid direct skin contact with oil. Brief contact may cause irritation while prolonged or repeated
exposure may lead to skin problems.
6 Remove the oil drain plug and allow used oil to drain into the empty reservoir.
7 While the used oil is draining, wipe the oil drain plug magnet clean of any metal shavings and
replace the seal.