CPN MC3 ELITE - Page 27

InstroTek
23
Choose the desired starting station number and press YES.
When Auto Store station is enabled, the station numbers will
increment up sequentially from the starting station number.
Choose YES to enable Auto Store to automatically store the
project after each reading. Otherwise, to store the data
manually, press the STORE key after each reading.
To use an existing Project or to print a Project, press the PROJECT
PRINT key on the front panel and select option 3.
Select Project from the list using the number choices.
To print, press the PROJECT PRINT key and select option 4.
Enable Auto Store?
Press YES or NO
3. Sel. Stored Proj.
4. Print Data
UP/DOWN for Next
Select #, ESC Exit
3. Sel. Stored Proj.
4. Print Data
UP/DOWN for Next
Select #, ESC Exit
Print Data
1. Print All Data
2. Print one Project
ESC to Exit