10. Select Language – Select either English or Spanish for the
language.
11. Set Units – Change units between lb./ft3, kg/m3, and
g/cc.
12. Standard Mode – Enable/Disable Average Standard
Mode, Decay Mode and Chi2 Test Mode.
13. Serial Number – Enter the serial number of the gauge.
14. Date/Time – Set the current date and time.
15. Buzzer ON/OFF – Enable/Disable the buzzer/alarm
function of the Elite.
16. Special Calibration – Adjust calibration constants for
local and special materials.
17. Nomograph Mode – Enable/Disable mode so the gauge
can be used on thin layer asphalt overlays.
18. Calibration Constants – Enter and store calibration
constants used for determination of the material density
and moisture. This function is for authorized users only.
Description of each MENU function
1. Recall
This function allows you to retrieve and review the most recent
test data.
1. Press the MENU button.
2. Press the 1 button.
3. You can now scroll through the test information.
2. Offset
There are three offset options in the gauge: Density, Moisture,
and Trench.
To Next Page
Loading...