CPN MC3 ELITE - Taking Measurements

InstroTek
20
Taking Measurements
Lower the source rod to the desired depth by pulling the
handle trigger back and pushing down on the handle. In
positions of measurement, always ‘lock’ in to the position by
allowing the trigger to engage the notch and then gently
pushing the handle down to ‘seat’ on the notch.
Caution: Never drive the source rod into the soil by hammering
the gauge handle down.
To start measurement, press START/ENTER. The gauge will then
begin taking counts.
After the gauge has completed its count time, it will display:
Depth: BS
Time: 15 sec.
If you exit out
of the results
information,
you can use
the Recall
function
under menu
to retrieve
your results.
M Count: ##
D Count: ##
MCR: ### DCR: ###
Press UP/DOWN
WD: #. # PCF
%MA: #. #
%Voids: #. #
Press UP/DOWN
Moist: #. # PCF
# DD: #. # PCF
%Mois: #. #%PR: #. #
PRESS UP/DOWN
To make
recording
this
information
easier, you
can set up
the Auto
Scroll Feature
under Menu.