T_LTING TABLE
1. To use the table in a bevel (tilted) position, do the fo_-
lowing:
a. Using an adjustable wrench, turn the nut (on the
table lock pin) clockwise. This will pull the table
lock pin out of its indexing hole in the table sup-
port.
b. Loosen the table bevel lock by turning it counter-
clockwise using an adjustable wrench.
c. Move the table so desired angle on the bevel
scale is straight across from the zero line on the
table support.
d. Retighten the table bevel lock.
WARNING: To avoid injury from spinning work
or tool breakage, always ciarnp workpiece and
backup material securely to table before oper-
ating drill press with the table tilted.
2. To return the table to the 90 ° position do the follow-
ing:
a. Loosen the table bevel lock.
b. Move the table and reinstall the table lock pin into
the indexing hole in the table support. Tap in gen-
tly into place.
c. lqghten the table bevel lock.
d. -lqghten the nut (on the table lock pin) finger tight
so it won't vibrate loose.
BEVEL
SCALE
TABLE
SUPPORT
TABLE LOCK PIN
NUT
HOLE LOCATION
Make a DENT in the workpiece where you want the
hole...using a CENTER PUNCH or a SHARP NATL.
Before turning the switch ON, bring the drill down to the
workpiece lining it up with the hole location.
FEEDING
Pull down on the feed handles with only enough effort
to allow the drill to cut.
Feeding TOO SLOWLY might cause the drill to
burn...Feeding TOO RAPIDLY might stop the
motor...cause the belt or drill to SLIP...tear the work-
piece LOOSE or BREAK the drill bit.
When drilling metal, it may be necessary to lubricate the
tip of the drill with cutting oil or motor oil to prevent burn-
ing of the drill tip.
27
To Next Page