WARNING: To avoid injury from unexpected
starting or electrical shock, do not plug the
power cord into a source of power. This cord
must remain unplugged whenever you are
working on the drill press.
Model 113.213213 Drill Press is shipped complete in
one box.
1. Unpacking and Checking Contents
a. Separate all "loose parts" from packaging materi-
als and check each item with "Table of Loose
Parts" to make sure all items are accounted for,
before discarding any packing material. Some
loose parts are contained inside the belt guard.
Open the belt guard cover to find them.
WARNING: if any parts are missing, do not
attempt to assembDe drill press, plug in the
power cord, or turn the switch on until the
missing parts are obtained and are installed
correctly.
2. Remove the protective oil that is applied to the table
and column. Use any ordinary household type
grease and spot remover.
G
WARNING: To avoid fire or toxic reaction, never
use gasoline, naptha or simiSar highly volaUle
solvents to remove protective oil.
3. Apply a coat of paste wax to the table and column to
prevent rust. Wipe all parts thoroughly with a clean
dry cloth.
TABLE OF LOOSE PARTS
Rtem
A
B
C
D
E
F
G
H
Part Name Qty.
Table/Support Asrn ............................................ 1
Column Support Asm ........................................ 1
Owner's Manual ................................................. 1
Motor .................................................................. 1
Box of Loose Parts ............................................. *
Base ................................................................... 1
Head Asm .......................................................... 1
Bag of Loose Parts ............................................ 1
* Number varies; bags can contain other smaller bags.
Note: To make assembly easier keep contents of each
bag together and separate from contents of other bags.
E
To Next Page
Loading...
