BevMax_Media_Programming_10_6_10 Page 48 of 106
08/15/2013
3. Accept On Low Change – Press the 3 Key to bring up a screen.
Press the 3 Key will open a window allowing you to enter an amount using the numeric Keys.
A. This amount is the maximum amount of money that will be accepted by the
machine when the coin mechanism is low on coins and may not be able to
make change for a purchase.
B. The default setting is $0.00 and setting an amount higher than that could cause
the customer to be shortchanged.
C. Bill acceptance will not be allowed if there is less change than the value of the
bill available to be returned.
Once the amount has been entered, use the center section of the OK Key to accept the new amount.
4. Low Change Message – Press the 4 Key to bring up a screen.
Press the 4 Key will open a window allowing you to enter an amount using the numeric Keys.
This amount is the amount of change, that when reached, will cause a low change message to be
displayed on the screen.
Once the amount has been entered, use the center section of the OK Key to accept the new amount.
5. Credit for Failed Vend – Press the 5 Key to bring up a screen.
Press the 5 Key will bring up a screen that allows you to set an option in the case of a failed vend.
Use the numeric Keys to check and un-check the action that will
happen in the case of a failed vend.
1 = Return the credit to the customer.
2 = Hold the credit to allow another vend attempt.
6. Allow Consumer Overpay – Press the 6 Key to toggle between Yes and No.
Press the 6 Key will change the setting in the live window between Yes and No. This allows you to
set an option in the case there is not enough change to pay back, but will allow overpay and vend.
A. When the YES setting is selected, Consumer Overpay will be allowed. This means the vender is
allowed to vend with the risk of not being able to return the full amount of change.
B. When the No setting is selected, Consumer Overpay is not allowed. This means the vender is not
allowed to vend unless it is able to return the full amount of change.
MONETARY SECOND SCREEN
7. or 1. Correct Change Parms – Press the 7 or 1 Key to bring up a screen (Repeat). See above.
2. Card Revalue – Press the 2 Key to bring up a screen.
Press the 2 Key, from the second screen of the function screen, will toggle the setting in a live window
between On and Off.
1. With the setting in the ON position, a card can be re-valued.
2. With the setting in the OFF position, a card cannot be re-valued.
Correct Change Parms
5) Credit For Failed Vend
1) Return Change √
2) Hold Credit
Card Revalue
2) Card Revalue Off On
To Next Page
Loading...
