Need help?Do you have a question about the Creality CR-10 S4 and is the answer not in the manual?
General| Build Volume | 400 x 400 x 400 mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Connectivity | SD card, USB |
| Frame Material | Aluminum |
| Bed Leveling | Manual |
| Printing Technology | FDM (Fused Deposition Modeling) |
| Heated Bed | Yes |
| Nozzle Temperature | Up to 250°C |
| Layer Resolution | 0.1 - 0.4 mm |
| Printing Speed | Up to 180 mm/s, typically 40-80 mm/s |
| Supported Filament Types | PLA, ABS, TPU, Wood |
| Bed Temperature | Up to 100°C |
| Power Supply | 110V/220V |
To Previous Page