Crestron CCS-UC-1 - Configure Route Patterns

54
•
CCS-UC-1: Secure SIP Endpoint with Cisco UCM 11.0 Configuration Guide – DOC. 7991A
14. Under the
SIP Information
, perform the following procedure.
a. Enter the FQDN of the Cisco UBE and port of the Cisco UBE LAN
interface.
b. Select the
Secure SIP Trunk Profile_Crestron
as the SIP Trunk Security
Profile.
c. Select the configured Standard SIP Profile_Crestron SIP Profile.
15. Click
Save
.
Configure Route Patterns
Route patterns were configured for the following actions.
• To route calls from the Cisco UCM to the Cisco UBE towards PSTN GW
• To restrict caller ID on outgoing calls
To configure route patterns, perform the following procedure.
1. Navigate to
Call Routing
>
Route/Hunt
>
Route Pattern
.
2. Click
Add
New.
3. Enter the details desired and then click
Save
.
The route patterns 9.@ and \
+*
were configured to enable outbound dialing from Cisco
UCM to Cisco UBE using the access code “9” and using the “+”.
Cisco UCM: Route Pattern Configuration: Outbound Dialing Using Access Code 9 (1/2)