Crestron CCS-UC-1 - Software Requirements; Hardware Requirements; Product Description; Summary

2
•
CCS-UC-1: Secure SIP Endpoint with Cisco UCM 11.0 Configuration Guide – DOC. 7991A
The lab network consists of the following components:
• Cisco UCM cluster for voice features
• Cisco SIP phones
• Crestron Mercury as the secure SIP endpoints
• Cisco UBE (CUBE) to ensure secure signaling and media within the enterprise for
PSTN calls
Software Requirements
• Cisco Unified Communications Manager v 11.0.1.20000-2
• Cisco UBE v 15.6
• Crestron Mercury devices v 1.3291.00019.001 or 1.3318.0002 (for G729 testing)
Hardware Requirements
• Cisco UCS-C240-M3S VMWare Host running ESXi 5.5
• Cisco 3845 as PSTN Gateway
• Cisco UBE as an SBC
• Cisco phone models: 8961 (SIP) and 8945 (SIP)
• Crestron Mercury devices (2)
Product Description
The Crestron Mercury device is a complete solution for conference rooms. It acts as an
all-in-one touch screen, speakerphone and AirMedia
®
product for conference rooms
that integrate microphones and speakers into the user interface at the table.
Crestron Toolbox™ is used to discover and control all Crestron devices on the network.
The Crestron Mercury web interface is used to control the Crestron Mercury devices on
the network.
Summary
The Crestron Mercury devices, in secure mode, are configured on the Cisco UCM as
Assured Service (AS) SIP endpoints. The devices successfully register to the Cisco UCM
with digest authentication.
The sections below describe supported and unsupported features on a Crestron Mercury
device.
Features Supported
• Secure Mode: establishes a secure SIP and RTP session with the Cisco UCM
• Registration with digest authentication
• Basic calls with G729, G722, G711u, and G711a codecs
• Caller ID (limited to only calling number)