Crestron IV-CAMHK-12-SLVR-1B - Mounting

Product Manual — Doc. 9311C IV-CAMHK-12-SLVR-1B • 16
Mounting
Install the camera using the included 2-point shelf mount to ensure optimum stability. Since both PTZs
are moving frequently, a mount with a center-only connection to the camera can cause undesirable
shaking.
For the best possible tracking performance, observe the following mounting requirements.
l
Center the camera horizontally, facing the meeting participants.
l
Mount the camera at a height between 4ft (1.2m) and 6ft (1.8m). If the camera is mounted
lower than 4ft (1.2m) or higher than 6ft (1.8m) facial detection, audio location accuracy, and
shot quality may be affected.
l
The camera detects faces at a distance up to 25ft (7.6m). In rooms where people are further
away from the camera, satisfactory operation cannot be guaranteed.
To mount the camera:
1. Following diameter and position of the four installation holes on the bracket, drill four holes in the
wall.
2. Use four of the included anchors and mounting screws to attach the bracket to the wall.
3. Use the two tripod-style screws to affix the camera to the bracket.
CAUTION:This camera cannot be inverted.