Product Manual — Doc. 9311C IV-CAMHK-12-SLVR-1B • 18
Wiring
Connect the camera to power using the included 12VDC power supply. If cabling needs to be extended to
reach the camera, utilize a longer IEC power cord.
Network Connection
The camera must be connected to a network for initial configuration. Once configured, the camera does
not need be connected to a network. A consistent network connection is recommended in case any
configuration adjustments are performed later.
Video Output
To connect the camera to a conferencing codec or capture device, an HDMI or SDI connection is
required. SDI is recommended for longer cable runs of over 50ft (15m). USB converters are available for
both HDMI and SDI if the camera is to be connected to a computer or codec via USB.
Reference Audio
An echo cancellation signal is required for the camera to work correctly in video conferencing
applications. Refer to Echo Cancellation on page 28.
To Next Page
Loading...