51 • IV-CAMHK-12-SLVR-1B Product Manual — Doc. 9311C
Basic 1 Tab
The settings panel shown above also allows the camera resolution to be changed between 1080p, 1080i,
and 720p at frame rates of 25, 30, or 60.
The Baudrate setting sets the baud rate for serial communication (optional).
Protocols determines which control protocol will be used to control the camera using external hardware
or software. VISCA is recommended for maximum compatibility with 1Beyond and third-party
products.
Device Address sets the camera’s serial address.
NOTE: The right PTZ camera needs to be addressed by the main camera’s address +1. If the
camera’s address is 1, the left PTZ’s serial address is 2.
Verify Performance in Debug Mode
Select Debug to enable Debug Mode. Debug Mode is used to verify that the camera is operating
correctly. This is best tested in an active video conferencing meeting with a few participants in the room.
Debug Mode will shows the operation of camera’s detection algorithms overlaid on the Reference feed.
To Next Page
Loading...