Crestron IV-CAMHK-12-SLVR-1B - View the Connection Status

Product Manual — Doc. 9311C IV-CAMHK-12-SLVR-1B • 34
3. Under Network information, confirm that the ConnType (Connection Type) is correct for how the
camera is connected. Set it to either Static IP or DHCP.
By default, the camera is set to DHCP.
NOTES:
l
If an Ethernet cable is connected directly to the computer running the
1BeyondCameraManager software, the computer’s network port will need to be set to
an address on the same subnet in order to communicate with the camera.
l
If the camera is set to DHCPfor ConnType, it will receive its IPaddress dynamically
from a network router. This option does not work when the camera is connected
directly to the host computer for configuration.
l
If the installation requires a different static address (for example,The IP address of the
camera needs to be modified to match the subnet of the computer), enter the IP, Mask
and Gateway info and then click Modify.
4. After modifying the IP address, click Refresh to update the camera list.
5. Select the camera and click Add to Camera List. The Add panel appears where you can verify that
the camera’s network settings are correct. By default, 1Beyond cameras do not require any
administrator credentials to be controlled. Once added, the camera will appear in your camera
list.
View the Connection Status
When the 1 Beyond Camera manager software connects to a camera, the camera shows as connected
in the Main session and Sub session columns. These columns indicate the camera's main and
substreams connection status for IP(RTSP)video.
NOTE:When the chosen camera is set to match your IPaddress, its status will read connected for
both columns.
The following connection status messages can be shown for a camera:
l
Connected:The 1 BeyondCamera Manager software has received RTSPvideo streams from the
camera and has connected to the camera.
l
Connection Failed:The 1 BeyondCamera Manager software discovered the camera on the
network, but video streams cannot be received. The camera is likely connected to a different
subnet from the host computer.
l
Disconnected:The camera is not currently accessible on the network.
NOTE:When a camera is first connected to the network, it can take up to 30 seconds after
powering the camera on for it to be discovered by the 1 BeyondCamera Manager software. This is
because the camera performs a diagnostic routine prior to activating the video encoder.