Crestron IV-CAMHK-12-SLVR-1B - Protocol Tab

43 • IV-CAMHK-12-SLVR-1B Product Manual — Doc. 9311C
Protocol Tab
Select the Protocol tab to set a secondary connection to the camera from a control device (such as a
Crestron touch screen).
Protocol Tab
The following settings can be modified:
l
Enable:Use the drop-down menu to turn the secondary connection on or off.
NOTE:For 1 Beyond Intelligent cameras, asecondary connection is turned off by default, as it
is not required in most circumstances since port 5500 supports VISCAcontrol over TCP.
l
Protocol:Use the drop-down menu to select the communication protocol for the secondary
connection.
l
Camera as:Use the drop-down menu to select the role for the camera(such as server)for the
secondary connection.
l
IP:Enter the IPaddress for the secondary connection device. The default value of "0.0.0.0"should
be retained for most setups.
l
Port:Enter the port number for the secondary connection. The default value of "5500"should be
retained for most setups.
Select Save to save any changes made to these settings.