5 Inch Lectern/Wall Mount Touchpanel Crestron Isys
TPS-2000L
Video Setup Details
VIDEO
SCREEN
BUTTONS
DESCRIPTION*
Brightness
This button allows for an increase (
UP
button) and decrease (
DOWN
button) in
the video image brightness.
Contrast
This button allows for an increase (
UP
button) and decrease (
DOWN
button) in
the video image contrast.
Saturation
This button allows for an increase (
UP
button) and decrease (
DOWN
button) in
the video image saturation.
Hue
This button allows for an increase (
UP
button) and decrease (
DOWN
button) in
the video image hue.
Hide Controls This button returns the display to the video screen.
Default
Touchpanel responds with a prompt, "ARE YOU SURE?" Select
YES!
to reset
video parameters to their defaults**. Select
NO!
to return to the previous
screen.
Return This button reverts back to the SETUP MENU.
* Each screen has its own
Return
button to revert back to the SETUP MENU.
** Video default is 50% for each of the video parameters (brightness, contrast, saturation, and hue).
Screen Settings
SCREEN SETTINGS
SCREEN SETTINGS -
BRIGHTNESS
SCREEN SETTINGS – AUTO
BRIGHTNESS THRESHOLD
Screen brightness, orientation, and quality may need to be adjusted because of
ambient light conditions or personal preference. These screen attributes may be
automatically set via programming or be altered manually by selects made from the
SCREEN SETTINGS display, shown to the left. Press the Screen Settings button
from the SETUP MENU to access this screen. To return to the SETUP MENU and
save screen settings, select the Return button on the SCREEN SETTINGS display.
Screen settings are factory set to Brightness Auto, Orientation Upright, and LCD
Bias 95. Alterations to brightness, orientation, and LCD bias are performed on
subsequent screens after selecting the appropriate button.
BRIGHTNESS
Press the Brightness button to open the SCREEN SETTINGS – BRIGHTNESS
display. Manual controls are located on the left side and automatic controls are
located on the right side. Two buttons, ENABLE and DISABLE, are used to
determine whether the touchpanel brightness is controlled manually or automatically
via thresholds. Select the ENABLE button for automatic settings. Notice that a ‘net’
covers the manual controls on the left. The DISABLE button removes the ‘net’ to
permit manual advancements (use the UP button) and reductions (use the DOWN
button) to the screen brightness.
Choose the SETUP button on the SCREEN SETTINGS – BRIGHTNESS display to
open the SCREEN SETTINGS – AUTO BRIGHTNESS THRESHOLD display,
shown to the left. A photosensor on the front panel permits this exclusive light-
sensing touchpanel to automatically determine if the amount of light sensed exceeds
a set threshold value. This threshold value allows the touchpanel to switch between
daytime super bright (high brightness) and evening soft glow (low brightness)
automatically. The right side of this display shows the CURRENT VALUE as
detected by the photosensor. This value, represented by xxx in the illustration, can
range from 0% (dark) to 100% (very bright). The THRESHOLD VALUE located on
the left side of the display needs to be set to automatically adjust brightness. The
numerical value, represented by xxx in the illustration, can range from 0% (dark) to
100% (very bright). Use the UP and DOWN buttons to increase and decrease the
THRESHOLD VALUE, respectively.
10 • 5 Inch Lectern/Wall Mount Touchpanel: TPS-2000L Operations Guide – DOC. 5972A
To Next Page
Loading...
Need help?
General
