Crestron TSR-310 Supplemental Guide

14 • TSR-310: Handheld Touch Screen Remote Supplemental Guide – DOC. 8226D
• Tap Set as Preferred to set the selected WAP as the preferred WAP. Tap
Remove Preferred to remove the selected WAP as preferred.
NOTES:
∙ The TSR-310 attempts to establish a connection to the preferred WAP by
default.
∙ A star icon displays to the left of the preferred WAP on the
Manage WAPs screen to indicate that the WAP is selected as preferred.
• Tap Delete to delete the selected WAP. If a WAP is deleted, it must be added
back to the list using the procedures described in "Select an Access Point" on
page
8.
Tap < BACK to return to the Wireless Setup screen.
IP Settings
On the Wireless Settings screen, tap IP Settings to display the IP Settings screen.
IP Settings Screen
Use the IP Settings screen to configure IP, DHCP (dynamic host configuration protocol),
and hostname settings for the TSR-310.
DHCP may be enabled or disabled by tapping On or Off under DHCP Enabled. When
DHCP is disabled, the
Set Static IP Address Settings button is used to configure static
IP address settings.
NOTE: DHCP is enabled by default.
To change a static IP address, tap Off under DHCP Enabled, and then tap Set Static IP
Address Settings to display the Static IP screen.

Crestron TSR-310 Specifications

General

Brand	Crestron
Model	TSR-310
Category	Remote Control
Language	English