134 • TSW-70 Series Product Manual — Doc. 8550E
To remove the touch screen after installation, use the included release key to push down on the
security bracket release tabs as shown in the following illustration while gently pulling the touch
screen away from the mounting bracket.
Connect the Touch Screen
Route all necessary cables through the rear of the mounting bracket, and then make connections
to the side of the touch screen rear housing.
Observe the following when connecting the touch screen:
l
Power and data connection is provided to the touch screen by a single Ethernet cable. A
Crestron PoE (Power over Ethernet) power supply, such as the PWE-4803RU, or a PoE-
capable network switch is recommended (neither included).
l
Apply power after all connections have been made.
To Next Page
Loading...
