Crestron TSW-70 Series User Manual

142 • TSW-70 Series Product Manual — Doc. 8550E
Ethernet Setup
Tap Ethernet Setup on the Setup screen to display the Ethernet Setup screen.
Ethernet SetupScreen
Use the Ethernet Setup screen to view the touch screen MAC and IP addresses, subnet mask
address, default router address, primary and secondary DNS addresses, hostname, and domain.
A Link indicator is provided to indicate the status of the Ethernet connection. (Green indicates
that the Ethernet connection is active.)
The following buttons are provided for configuring Ethernet settings:
l
Tap On or Off under LAN Access to turn the Ethernet adapter on or off. If LAN Access is
set to Off, Ethernet will not function and a Wi-Fi connection can be established.
l
Tap On or Off under DHCP Enable to turn DHCP (dynamic host configuration protocol) on
or off.
NOTE: DHCP is turned on by default.
l
If DHCP is turned off, tap Set Static IP Address Settings to enter static IP addresses
manually.
l
Tap Set Hostname to enter a new touch screen hostname using an on-screen keyboard.
l
Tap APPLY CHANGES to apply any new Ethernet settings to the touch screen and to stay
in setup mode.
l
Tap REBOOT to exit setup mode and reboot the touch screen.
To change a static IP address, tap Off under DHCP Enable. Then, tap Set Static IP Address
Settings to display the Static IP Ethernet Setup screen.

Crestron TSW-70 Series Specifications

General

Brand	Crestron
Model	TSW-70 Series
Category	Touch Panel
Language	English