thecrowgroup.com Page | 39
System tamper to output
This option is used for indication of panel tamper
alarm by specified Output. This option works in
arm or stay arm state only and The Output turns to
on.
Sensor-watch to output
This option is used to assign a Sensor-Watch
alarm to an Output. A Sensor-Watch alarm occurs
when a detector has not operated
within a set period of time. Zone sensor watch
time can be set in zone level per each zone(in
minutes)
Duress Alarm to Output
Duress Alarm can be assigned to an Output or
multiple Outputs. This can be used to operate an
audible or visual alarm connected to the Output.
Walk Test Pulse to Output
When the panel is in Walk-test Mode, this option
assigns a one single pulse (one chirp) to the Output
every time a zone is triggered.
disable
Pendant Panic, Fire, Medical
Alarm to Output
A Pendant Panic Alarm can be assigned to an
Output or multiple Outputs. This can be used to
operate an audible or visual alarm connected to
the Output
disable
To Next Page
Loading...