7
3.4 Fuse Replacement
This radio adopt 5A, 250V fuse
.
If the fuse blows, determine the cause, then correct the problem. After
the problem is resolved, replace the fuse. If newly installed fuses
continue to blow, disconnect the power cable and contact your autho-
rized
dealer or an authorized servi-
cecenter
for
assistance.
1. Open the fuse holder
, 250V FUSE
IN-LINE
FUSE HOLDER
5A
2. Replace the fuse and screw on the holder.
Only
use fuses of the specified type and rating, otherwise the
transceiver could be damaged.
FUSE
IN-LINE
FUSE HOLDER
IN-LINE
FUSE HOLDER
IN-LINE
FUSE HOLDER
Fuse Location Fuse Current Rating
Transceiver 5A
Supplied Accessory DC
power cable
5A
»
If you use the transceiver for a long period when the vehicle
battery is not fully charged, or when the engine is OFF, the
battery may become discharged, and will not have sufficient
reserves to start the vehicle. Avoid using the transceiver in
these conditions.
To Next Page
Loading...
