13
5. WORKING MODE AND MENU FUNCTION
According to practical application, you can set the radio works as
Amateur Transceiver mode or Professional Transceiver mode. There
are also 2 levels operati
on
menu to set functions as you need. It
is easy and convenient (From No.1 to No. 10 are channel function
setup, From No.11 to No.20 are general setting setup).
5.1 Working Mode
A. By programming software: In PC software's "General Setting"
menu, choose "Display Mode" to select Amateur Transceiver
mode or Professional Transceiver mode.
B. By manual setup: Please refer to "Display Mode" in Page 23.
5.2 Amateur Transceiver Mode
Except setting as "CH" mode, others considered as Amateur
transceiver mode. Under this mode, press [V/M] key to switch
between Channel mode and VFO mode.
A. Frequency + Channel mode: When set display as "FR", it enters
into Frequency+ Channel mode. Under this mode, new setting
of channel operation and shortcut operation can be temporarily
used by user. Once the radio is turned off or switched to another
channel, the temporary setting will be erased and back to initial
settings. If the program software’s channel store is valid, the
Shortcut operation and channel setting will be changed & stored
as the latest value permanently. Once the radio is turned off or
changed to new VFO frequency, the latest setting is remained until
next change.
B. Channel+ Name Tag Mode: When set display as "NM", it enters
into Channel +Name Tag mode. At this mode, it will display
corresponding channel name when the current channel is edited
with name. Otherwise, it will display frequency + channel. Its
operations are the same as frequency + channel mode.
C. VFO Mode(Frequency mode): Under this mode, the Shortcut
operation and channel setting will be changed & stored as the
latest value permanently. Once the radio is turned off or changed
to new VFO frequency, the latest setting is remained until next
change.
(only for amateur version)
To Next Page
Loading...
