25
1. Double click
"SPACE-Setup.exe", then follow the installing
instruction.
2. Click start menu in computer, under "ALL PROGRAMS" menu,
choose and click "USB To Com port" in SPACE program, install “USB
To Com port” driver by indication.
3. Connect the optional USB Programming cable to USB port in PC
with transceiver.
4. Double click SPACE shortcut or click SPACE inprocedure index of
start menu, choose serial com port as indicated then click OK to
start programming software.
5. According to instruction, select correct "COM Port, then click "OK"
to start programming software.
8. PROGRAMMING SOFTWARE INSTALLING
AND STARTING
»
Even in same computer, the selective COM Port is different
when USB cable connects with different USB port.
You shall install software before connecting the USB cable line.
Switch on transceiver before writing frequency. You had better not
switch on or off the power supply of transceiver when it is connected
with computer, otherwise, it will make transceiver unable to read
or write frequency. In this case, you have to turn off programming
software, pull out USB cable. then reinsert USB cable and open
software, then rechoose COM Port, it will turn into normal operation.
Therefore, please connect transceiver with computer after switching
on the transceiver. Don't restart transceiver power when it is
connected with computer.
To Next Page
Loading...
