CRT Space-U - Scan Skip; CTCSS;DCS Encode and Decode Setup

18
7.05 Scan Skip
In channel mode, separately short press [FUN] key and [SCA] key to
add or delete a scan channel.
1. Decimal point between frequency's ten digit and unit digit
disappears, the current channel added to scan list. this channel will
be scanned when scan function start.
2. Decimal point display between frequency's ten digit and unit digit,
the current channel is deleted from scan list, this channel will not
be scanned when start scan function.
7.06 CTCSS/DCS Encode and Decode Setup
Separately short press [FUN] key and [SQL] key to enter CTCSS/
DCS encode/decode menu, repeatedly short press [SQL], to set
CTCSS/DCS encode/decode for current channel.
1.
When the LCD displays T , means current channel set with CTCSS
encode, press [UP]/[DN] key or turn VOL knob to choose wanted
encode.
2. When the LCD displays CT, means current channel set with
CTCSS encode/decode, press [UP]/[DN] key or turn VOL knob to
choose wanted CTCSS decode.
3. When the LCD displays DCS, means current channel set with DCS
encode/decode, press UP/DN key or turn VOL knob to choose
wanted DCS encode/decode.
4. CTCSS code: 62.5-254.1 total 51 groups. DCS code: 000N-777I
total 1024 groups, N is positive code, I is inverse code. Press V/M
to choose positive code or inverse code.
5. Press [UP]/[DN] key or any other key except volume knob to exit.
»
Under channel mode, this operation can be temporarily used
by user. Once the radio is turned off or switched to another
channel, the temporary setting will be erased. If the channel
setting programmed for valid, the temporary setting will keep
valid until next change, turn off radio or switch to another
channel, the temporary setting will not changed.