24
7.26 Squelch Level Setup
Enter No.16 function menu , the LCD displays "SQL"
This function use for setting RX signal strength, the calling will be
heard only when reach set level, otherwise the radio will keep mute.
OFF-09: Total 10 levels, OFF is lowest value(Open)
Default: 03
7.27 Scan Dwell Time Setup
Enter No.17 function menu , the LCD displays "SCAN"
This radio has 3 kinds of Scan Dwell Time way.
SE: It stops once scanning a matching signal.
TO:
It pauses 5s once scanning a matching signal, then resume scan.
CO: It pauses once scanning a matc
hing
signal, signal disappeared
then resume scan.
Default: TO.
7.28 Power On Method Setup
Enter NO.18 function menu, the LCD displays "AOP"
After turn off this function, the transceiver will be power on only by
manually pressing VOL key.
ON: Auto-power on
OFF: Power on by manual
Default: ON.
7.29 Mic Gain Setup
Enter No.19 function menu, the LCD displays "MIG".
1-16: total 16 levels for optional
Default: 6
7.30 Reset Factory Default
Enter No.20 function menu , the LCD displays "RESET".
If your radio seems to be malfunctioning, resetting the microprocessor
may solve the problem.
FACT: All channel, signaling function setup resume factory default.
SETUP: No.10-20 function menu setup resume factory default.
»
If the transceiver has set at higher squelch level, it may fail to
hear the calling. If set at lower squelch level, the radio will be
interfered.
To Next Page
Loading...
