16
»
Hold PTT key, the LED lights red and power strength show in
the screen, indicates it is transmitting, release PTT to receive.
6.07 Transmitting
Hold [SQL] key to monitor for a while, to conrm the current channel
is not busy, then release [SQL] key and back to standby state .
Hold [PTT] key and speaker into microphone. Hold the microphone
approximately 2.5-5.0cm from your lips and speak into the
microphone in your normal speaking voice to get best timbre.
If the transceiver LCD display BUSY icon and eld strength, the green
LED Rx indicator ashes, but can not hear the calling, it means has
receive matching carrier but with unmatching signaling ( Pls reference
CTCSS/DCS encode and decode for operation).
6.08 Channel Edit
1. In VFO mode, press [UP]/[DN] or [VOL] to choose wanted frequency.
2. Press [FUN] key+ [SQL] to enter CTCSS/DCS setup. Press [UP] /
[DN]or [VOL] to select desired signaling.
3. Enter channel menu No 1-10 and choose related setup.
4. Press [FUN] key, the LCD displays F icon, if the channel number
ash means current channel number is valid. If M icon ashes means
current channel number is empty.
5. Press [UP] / [DN] key or turn VOL knob choose wanted channel
number.
6. Press [V/M] key store the channel, the decimal point icon disappear,
the channel number no ash and emit a prompt, it means the channel
stored success.
6.09 Channel Delete
1. In channel mode, press [UP] / [DN] to choose a unwanted channel.
2. Hold [FUN] and [V/M] key for over 1 second, the current channel
will be deleted, the radio emit a prompt and jump to next working
channel.
To Next Page
Loading...
