52
L510023-07
7. Check Water & Exhaust Hoses for Proper Connection
• Attach hoses removed for winterization.
• Inspect each hose for leaks, routing, rubbing and cuts or abrasions. Correct
any defi ciency.
• If equipped, check to insure that the strainer is not damaged and seal is
secure. Correct any defi ciency.
• If equipped, check to insure that the hull inlet valve is turned to its OPEN
position.
• Check Fresh Water Cooling to insure that the coolant level is proper. Coolant
level in the Degas Bottle should be at the ‘MAX’ line on the bottle.
IMPORTANT: The addition of accessories, either by the Dealer or Boat
Manufacturer, i.e. a hot water heater or heater, to the engine’s freshwater
coolant system, increases the volume of the engine’s coolant system and will
require additional coolant to be added. Be sure to use Dex-Cool™ extended
life coolant when topping off the Fresh Water Cooling System.
NOTICE: The boat manufacturer/dealer selects and installs the water/exhaust
hoses and accessories to the engine. Problems associated with these hoses,
accessories, or their installation should be corrected at the direction of the
boat manufacturer and/or installer and are not a Crusader Warranty item.
8. Install and Tighten all Drain Plugs
• The drain plugs have been removed for shipping or winterization. Before the
engine may be safely started the drain plugs must be installed.
• Insert a plug of the proper size coated with PST (Pipe Sealant with Tefl on by
Loctite or equivalent) into each drain location.
• Tighten each drain plug securely. Caution ! Do Not Over Tighten Or Damage
Could Occur.
• Check the compliance box on the procedure.
9. Visual Check of Belt And Pulley Alignment
NOTE: All Crusader engines currently use a serpentine belt at the front of the
engine. This belt has a self-tensioning system which is non-adjustable.
• Check belt for cuts or other damage. Correct any defi ciency.
• Check the pulleys for damage. Correct any defi ciency.
• Visually inspect for pulley and belt alignment. Correct any defi ciency.
PORT STBD
PORT STBD
PORT STBD
To Next Page
Loading...
