Chapter 3. Operation
Upgrade Procedure
Select the upgrade option; "1" upgrade the mainboard firmware, or "2" upgrade the FPGA
firmware.
Answer "y" to the confirmation message "Are your sure ….."
Now start the Xmodem file transfer. Here is an example using HyperTerminal.
34
1. Transfer & Send File
2. Browse and find the binary
3. Select Xmodem protocol…
4. Send… 5. Monitor the transfer…
LOCAL << Upgrade Firmware using the XMODEM console >>
1. Upgrade the Main Board Firmware
2. Upgrade the FPGA Firmware
=======================================
<< Upgrade the Main Board Firmware>>
Are you sure you wish to proceed with the upgrade (Y/N) ? Y
Please start XMODEM file transfer on your Terminal.
********************************************************************
Warning : DO NOT power off or terminate the file transfer during the
upgrade process or the Flash will crash, leaving the system
unstable.
********************************************************************
Upgrading now ..
To Next Page
Loading...
Need help?
General