CTM 360a series - Page 76

TROUBLESHOOTING
9-2
PROBLEM
POSSIBLE CAUSE
SOLUTION
LABEL DOES NOT ADVANCE
NIP ROLLER NOT ENGAGED
INSPECT AND CORRECT
WHEN THE APPLICATOR IS
AGAINST DRIVE ROLLER
ONLINE AND JOG IS PRESSED
DRIVE BELT IS BROKEN
REPLACE BELT
LOST KEY IN DRIVE PULLEY
FOLLOW PROCEDURE FOR SLIP
CLUTCH ADJUSTMENT. WHEN YOU
GET TO STEP #6 AND HAVE REMOVED
THE PULLEY GOING TO THE REWIND,
GO AHEAD AND REMOVE THE DRIVE
PULLEY. REPLACE KEY AND PUT
BACK TOGETHER
LABEL DOES ADVANCE BUT DOES NOT
LABEL SENSOR NEEDS SET UP
REFER TO LABEL SENSOR SETUP
STOP IN THE SAME PLACE EVERY
IN THE “LABEL SETUP” DISPLAY
TIME OR DOES NOT STOP IN THE
SECTION OF THIS MANUAL
RIGHT PLACE
LABEL SENSOR NOT LOOKING
MOVE LABEL SENSOR OVER THE
AT A LABEL
LABEL PATH
LABEL SENSOR OR FIBER CABLE
REPLACE LABEL SENSOR
IS DAMAGED
NIP ROLLER NOT ENGAGED
INSPECT AND CORRECT
AGAINST DRIVE ROLLER
LABEL LENGTH SET WRONG
REFER TO LABEL LENGTH SETUP
IN THE “LABEL SETUP” DISPLAY
SECTION OF THIS MANUAL
LABEL STOP SET WRONG
REFER TO LABEL STOP SETUP
IN THE “LABEL SETUP” DISPLAY
SECTION OF THIS MANUAL