CTM 360a series - Page 77

TROUBLESHOOTING
9-3
PROBLEM POSSIBLE CAUSE SOLUTION
LABEL LINER NOT WINDING UP
REWIND SLIP CLUTCH NEEDS
SEE SLIP CLUTCH ADJUSTMENT
TENSIONING OR REPLACED
IN THE MAINTENANCE SECTION
ONE-WAY CLUTCH BEARING
REPLACE REWIND SHAFT ASSEMBLY
NOT WORKING
BROKEN BELT
REPLACE BELT
LABELS ARE NOT HELD ON LABEL
AIR BLOW
CHECK FOR BLOWN FUSE
GRID OR LABEL PAD
VACUUM FAN NOT WORKING
OBSTRUCTION IN FAN
REPLACE FANS
TAMP
INSPECT FOR CLOGGED OR
NOT ENOUGH VACUUM ON PAD
DEFECTIVE VENTURI
VENTURI EXHAUST IS BLOCKED
NEEDS MORE AIR PRESSURE
BOTH AIR BLOW & TAMP
REFER TO PEEL EDGE ALIGNMENT
PEEL EDGE OUT OF ADJUSTMENT
IN THE LABELER SETUP SECTION
(SECTION 7)