Cube 3d printer User Manual

49
3. Press the “Z” up key to move the print pad upward to the print tip until the paper is tight between the print pad and the print
tip. Finger tap the down key until the paper slides back and forth with no resistance.
4. Press the check mark to save setting to printer’s memory. Press the X in box to cancel setting. If saving the setting, the
“Gap” value will be applied for each subsequent print.
5. If you have issues printing after the gap have been saved, you can change the gap at anytime using this procedure.
6 Once gap is set, tap PREV to start “Load Cartridge” process.
Tap Here

Cube 3d printer Specifications

General

Filament Diameter	1.75 mm
Nozzle Diameter	0.4 mm
Connectivity	Wi-Fi, USB
Supported Materials	ABS, PLA
Technology	Fused Deposition Modeling (FDM)