JetCount
®
Currency Counter
All Models
If there is heavy buildup on the aluminum rollers, remove it with a
clean, soft eraser as shown.
7.
Use a Simple Green Safety Towel to clean all rubber sections
of the large, black feed rollers. Rotate the rollers.
Also clean the flat, center rubber-drive tire, as identified at left.
8.
Use a microfiber towel or vacuum to remove any remaining dust
in the bottom stacker.
9.
Use a microfiber towel to clean the stacker-sensor lens located in
the stacker tray between the two gray stacker wheels.
Clean the stacker mirror located directly across from the stacker-
sensor lens.
10.
Replace feeder plate. Insert curved edge of feeder plate first.
Gently press down on feeder plate until it snaps into position.
11.
Clean exterior surfaces as necessary with a Simple Green Safety
Towel.
To Next Page
Loading...