Returned Error Value Description
BAD_ID 1 Bad Index (device ID)
PT_RANGE 2 Variable Table Access out of range
AUTO_RUN 3 Attempt to access element running automatically
UNIT_UNDEF 4 Element accessed before being setup
PARAM_RANGE 5 Parameter is out of range
UNIT_BUSY 6 Unit is already busy
NO_FLASH_BLOCK 7 Could not find the specificed flash block
FLASH_CHECKSUM 8 Flash block checksum is bad
TASK_OVR_RUN 9 Task queue overrun
NO_INIT 10 Tried to execute before initialization
CMD_END 11 Found end of table command
BAD_ENDIF 12 Bad End If location
CALL_OVF 13 Too many call statements
CALL_UNF 14 Too many return statements
OP_BAD 15 Undefined op-code
OP_UNKN 16 Unknown op-code
FUNC_IND 17 Function index is out of range
VAR_IND 18 Variable index is out of range
EVAL_OVF 19 Evaluation stack overflow
EVAL_UNF 20 Evaluation stack underflow
RESULT_OVF 21 Result stack overflow
RESULT_UNF 22 Result stack underflow
LOW_IPMS 23 Not enough instructions per millisecond
BAD_BAUD 30 Bad CAN Baud Rate
BAD_MO_ID 31 Bad Mailbox ID
BAD_MO_LEN 32 Bad Mailbox Length parameter
MO_INACTIVE 33 Attempt to access an inactive mailbox
MO_SENDING 34 Resending a message before old one sent
MO15_XMIT 35 Attempt to set mailbox to transmit
TYPE_UNDEF 40 Accessed a limit block with an undefined type
TYPE_SETUP 41 Accessed a limit block with a bad type specifier
TYPE_RUN 42 Bad type specifier in limit block while running
BAD_EEADD 43 EEPROM Address is out of range
BAD_DEFAULTS 44 Parameter Block Default Values are not up to date
PARAM_RO 45 Tried to Write to a Read-Only Parameter
BAD_P_TYPE 50 Pot Type out of Range
ENC_PHASE 51 Encoder phase error
1310 Vehicle Control System Users Manual Release Rev B Page 45 of 51
To Next Page
Loading...
Need help?
General
