Curtis 1310 User Manual

3- PROGRAMMA B LE PARAMETERS
PROGRAMMABLE PARAMETERS
The Curtis 1310 Vehicle System Controller is designed a universal programmable control block
and has only a few standard parameters that can be programmed using a Curtis 1311 handheld
programmer. Using VCL, many custom parameters and menus can be added to meet the needs
of the application. Refer to section 5 of the VCL Programmers Guide for detailed information on
setting up parameter lists and menus that can be read by the Curtis 1311 handheld or Curtis 1314
PC based programmers. For basic information on Curtis 1311 handheld programmer operation,
see Appendix C.
PROGRAM MENU
The following sub menus are found under the PROGRAM Menu;
BATTERY
Nominal Voltage
Reset Volts Per Cell
Full Volts Per Cell
Empty Volts Per Cell
Discharge Time
BDI Reset Percentage
CAN Interface
Master ID
Slave ID
BAUD Rate
Heartbeat Rate
PDO Timeout Period
Emergency Message Rate
Suppress CANOpen Init
1310 Vehicle Control System Users Manual Release Rev B Page 19 of 51
3

Curtis 1310 Specifications

General

Brand	Curtis
Model	1310
Category	Controller
Language	English