3. PRINTER FUNCTIONS
KPM216H
103-
spacing.
• The GS P command can change the horizontal (and vertical) motion unit.
However, the value cannot be less than the minimum horizontal movement
amount.
• In standard mode, the horizontal motion unit is used.
• The maximum right side spacing is:
255/204 inches for the 204 dpi model
255/300 inches for the 300 dpi model.
[Default] n = 0
[Reference] GS P or GS $D0
[Example]
n!CSE
[Name] Select print modes
[Format] ASCII ESC ! n
Hex 1B 21 n
Decimal 27 33 n
[Range] 0 ≤ n ≤ 255
[Description] Selects print modes using n (see table below):
tiBnO/ffOxeHlamiceD
nuFnoitc
)ipd002(ipc51/11
)ipd003(ipc32/71
)ipd002(ipc02/51
)ipd003(ipc03/32
0
ffO000
.detcelesAtnofretcarahC
42x8142x31
nO101
.detcelesBtnofretcarahC
42x3142x01
1- - -
.denifednU
2- - -
.denifednU
3
ffO000
.detcelestonedomdednapxE
nO808
.detcelesedomdednapxE
4
ffO000
.detcelestonedomthgieh-elbuoD
nO0161
.detcelesedomthgieh-elbuoD
5
ffO000
.detcelestonedomhtdiw-elbuoD
nO0223
.detcelesedomhtdiw-elbuoD
6
ffO000
.detcelestonedomcilatI
nO0446
.detcelesedomcilatI
7
ffO000
.detcelestonedomenilrednU
nO08821
.detcelesedomenilrednU
[Notes] • The printer can underline all characters, but cannot underline the spaces
set by HT, ESC $, ESC \ and 90°/270° rotated characters.
• When characters are enlarged to different heights on one line, the
characters are aligned at the baseline or topline (see GS ~).
• This command resets the left and right margin at default value (see GS L,
GS W).
• ESC E can also be used to turn the emphasized mode on/off. However,
To Next Page