CUSTOM/POS emulation
-
tance” parameter. (see par.5.4).
For example, to set a notch distance of 15mm between the notch and the alignment point, the parameters must be set on
the following values:
Notch Distance Sign : +
Notch Distance [mm x 10] : 1
Notch Distance [mm x 1] : 5
: 0
during the Setup procedure of the device (see chapter 5)
by using the 0x1D 0xE7 command (for more details, refer to the Commands Manual)
by driver
SVELTA emulation
by using the parameters of the <LHT> command (for more details, refer to the Commands Manual)
by driver
“Ticket X Dimension”
“Ticket Y Dimension”
“Notch Width”
“Notch Distance”
PRINTING DIRECTION
“Notch Distance”
“Notch Width”
“Ticket X Dimension”
“Ticket Y Dimension”
Alignment
point
113
To Next Page
Loading...
