NOTCH/B.MARK
MIN. WIDTH
Minimum length of the alignment notch:
0 mm
D
6 mm 12 mm 18 mm
1 mm 7 mm 13 mm 19 mm
2 mm 8 mm 14 mm 20 mm
3 mm 9 mm 15 mm
4 mm 10 mm 16 mm
5 mm 11 mm 17 mm
NOTES:
If the “Notch/B.Mark Position” parameter is disabled, the parameter is not printed.
The parameter “Notch/B.Mark Min. Width” is used to set the notch dimensions in order to avoid that other
graphics present on the ticket can be detected as a Notch/B.Mark.
TICKET LOCKING This parameter enables/disables the block of the paper inside the device where the ticket
is not cut with the cutter, but is presented for the manual tear off by the user:
Disabled
D
= paper block disabled
Enabled = paper block enabled
NOTE: If the “Notch/B.Mark Position” parameter is disabled, the parameter is not printed.
TICKET MANAGEMENT This parameter allows the ticket management:
Disabled
D
= no check
CASING TYPE Type of device casing:
Plastic
D
= plastic casing
Metal = metallic casing
NOTE:
The parameter is printed only for TK180 models.
PRINTHEAD TEST
POWERON
Setting of the performing of the print head test:
Disabled
D
= the test is performed only during the printing of the setup report
Enabled = the test is performed at each power on
PRINT DENSITY Adjusting the printing density:
-50% -12% +25%
-37% 0
D
+37%
-25% +12% +50%
67
To Next Page
Loading...
