EasyManua.ls Logo

Custom Audio Electronics Venere - GETTING STARTED; Installing SIM, Battery, and Storage Card

Custom Audio Electronics Venere
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2 GETTING STARTED
2.1 Installing the SIM card, battery, and stor-
age card
You need to remove the back cover before you can install the SIM
card and battery. Also, make sure to always turn off the power
before installing or replacing the SIM card and battery.
To remove the back cover
1. Make sure your device is turned off.
2. Firmly hold the device with both hands and the front panel
facing down.
3. Push the back cover up with your thumbs until it disengages
from the device and then slide it up to remove.
To remove the battery
1. Make sure your device is turned off.
2. Remove the back cover.
3. The bottom of the phone has a notch. Lift the battery by the
notch to remove it.
To install the SIM card
The SIM card contains your phone number, service details, and
phonebook/ message memory. Your device is supported 2G, 3G
(WCDMA) or 4G (FDD_LTE) SIM cards.
1. Remove the battery if it is installed.
2. Locate the SIM card slot, and then insert the SIM card with
its gold contacts facing down and its cut-off corner facing out
the card slot.
3. Slide the SIM card completely into the slot.
65

Table of Contents