Custom Audio Electronics VKP80III - Low Paper Sensor

5.5 Low paper sensor
The device provides as an accessory (see
chapter 11
sensor, use an M3 screw not supplied.

MATERIAL INCLUDED
MATERIAL NOT
INCLUDED
Fixing screw M3
23018.2
10 210
12.5
Low paper sensor
Low paper
sensor board
ConnectorLow paper wiring
For the assembly procedure, proceed as follows:
Low paper sensor board
Spacer
Low paper sensor
Low paper wiring
Paper roll
Support
B
from 1 mm to 6 mm
A+B
A
Fix the low paper sensor board to the support by using an M3 screw not included.
For the correct functioning of the low paper sensor, comply with the measures specified.
1
39