Custom Engineering B202H - Page 63

PRESENTER OFFSET
[mm]
Setting of the presentation distance of ticket in case of presentation mode enabled
(paper cut disabled).
The numeric value of the presentation distance is made up with the following three
parameters for the setting of two digits (two for the integer part of the number) and
of the sign:
PRESENTER OFFSET SIGNUM
Sign setting:
+
D
= positive value
- = negative value
PRESENTER OFFSET [mm x 10]
Setting the digit for tens:
0
D
4 8
1 5 9
2 6
3 7
PRESENTER OFFSET [mm x 1]
Setting the digit for units:
0
D
4 8
1 5 9
2 6
3 7
NOTE: For example, to set the presenter offset to 10 mm, modify the parameters as follows:
Presenter Offset Signum = +
Presenter Offset [mm x 10] = 1
Presenter Offset [mm x 1] = 5
ALIGN TICKET
This parameter defi nes when the device must perform the automatic alignment of
the ticket:
Disabled
D
= alignment disabled
Power On = alignment at each power on
Autoload = alignment at each paper loading
P.On/Load = alignment both at power on and at paper loading
NOTE: At each alignment, printer performs an ejection of the fi rst inserted ticket in order to ensure the
integrity of the fi rst printed ticket.
RFID ENCODING
Setting of the coding system used for the writing of the RFID chip:
AEA standard
D
Custom01
5. CONFIGURATION
User manual KPM150H-AERO 63