3) Enter:
value
1 in the field Clear variables zone,
value
1 in the field Clear punches-dies zone
and value
817 in the field EXECUTION CODE.
Press the
key.
Press the
key twice.
4) Enter:
value
1 in the field Clear variables zone,
value
1 in the field Clear punches-dies zone,
value
1 in the field Clear machine parameters zone
and value
817 in the field EXECUTION CODE.
Press the
key.
Press the
key twice.
T
c
he clearing of the machine parameters deletes also all the input / output
onfiguration defined by the operator.
It is therefore advisable to re-configure the DNC 600S before the next use.
Caution: If you use an external system for the data re-introducing
(CYBACK via RS232) and the problem persists, then the informations re-
entered by this system have to be called into question.
The best to do in this case is to delete again the whole contents of the DNC
and to re-program the DNC manually via the keyboard (not the RS232 line).
PAGE 56 USER GUIDE DNC 600S
To Next Page
Loading...
