BOTTOMING
As for most work under pre n
the center of the press.
e
ssure, it is preferable to do this type of bending i
Delete th fiel
Delete or leave the Y
The press makes the descen
the bottom of the die with th .
The DNC es that the beam
switch
ANGLE CORRECTION
d.
1 and Y2 fields unprogrammed.
t in the conventional way until the beam stops in
e pressure of the current sequence
not has stopped and the ascent cycle is then
ed on.
the angle bent an the angle
he real value of the angle
lues in consequence.
This pa lay the corrections on the calculated
axi bend.
Call th ge by pressing the
It can happen that is slightly greater or less th
programmed.
The operator has then the possibility to introduce t
bent. Th d Y2 axis vae DNC will correct the Y1 an
ge allows to introduce and disp
s values for the current product and
e CORRECTION pa key.
Th a
e p ssage to the following or previous bend is made by using the or
keys.
N 1 CY __
-COR N- -COR P-
90.0°
MES ___._° ___._°
Y1 ___.__ ___.__
Y2 ___.__ ___.__
X ___.__ ___.__
APPENDIX G: MISCELLANEAOUS PAGE 71
To Next Page
Loading...
