COR N This column a
current sequen
llows to make a correction for the
ce only. (The wording COR N
may possibly not appear according to the
lumn allows to ake co e
e o
machine configuration, however it concerns
always the fields of the left column).
COR P This co m rrections on th
whole product in one singl peration.
Value of the angle programmed in the sequence.
mabl
red value.
This field is not program e on this page. It
simply repeats the desi
MES Value of the angle measured after bending.
field the DNC calculates
automatically the correction for Y1-Y2.
c ing h era ly
Y1, Y
The f
Program or call the product.
Pass to semi-automatic mode.
Execute the first bend.
sult.
Enter the measured angle in the COR N or COR P field (see above).
The DNC calculates automatically the corrections to apply in Y1 and
Bend a second product on the first bend, in order to control the
e way for the
following sequences.
tic m
Axes Y1-Y2 to intervene directly on the values of the Y1 and Y2
e
equence page
By leaving the
A cord to w ether the op tor will app
this correction to the current sequence or to all
the sequences having the same angle, the
measured value is to program in the COR N or
COR P column.
2, X, etc. Direct corrections on the axes.
ollowing working method is recommended:
Measure the re
Y2.
If necessary, make the corrections on the gauge axes.
corrections.
Pass to the next sequence and proceed in the sam
When all the bends are correct, pass to automa ode and produce
normally.
If the operator wishes
axes, he has to do it on this page directly in the Y1-Y2 fields, and not in th
s
.
PAGE 72 USER GUIDE DNC 600S
To Next Page
Loading...
