PROGRAMMING THE AXES DATUM
Select option 11 of the main menu, the following page appears:
AXES DATUM
--SET-- --POS--
X _____.__ 0.00
Y1 ____.__ ____.__
Y2 ____.__ ____.__
n the values for the axes datum.
n.
At this moment, the POS field takes the new value.
Dangerous Operation
Introduce in the SET colum
Leave the field for validatio
This operation can only be executed by an experimented operator who
knows the consequences of his modification.
th n of an axis in this way, make sure that it
lectronic, electrical
is should be the case however, a particular caution has to be
taken. In fact, if you modify here the position and an error is
committed, the damages caused by this modification can be dangerous
and/or harmful for the functioning of the machine.
Furthermore this modification get lost at each restarting of the
machine.
If you modify e positio
corresponds to the reality. After modifying, the e
and mechanical limit switches are to verify. Generally the axis in
question is displaced in manual mode slow speed up to the
negative/positive limit switch.
It is recommended not to modify Y1 and Y2.
If th
APPENDIX G: MISCELLANEAOUS PAGE 65
To Next Page
Loading...
