APPENDIX H: TRANSFER
For transfer to a PC by serial line the DNC 600S must be equipped with the
RS
Products The PC ipped with the CYBELEC PC1200 software with option
oducts in the bending
for execution.
Backup e equipped with the CYBACK storage software.
ws to make a backup of the data in the DNC without
Updating sity
Call the TRANSFER DNC <
--
> PC page via the main menu.
232 option.
must be equ
LINK7000. This combination allows to create pr
software on PC and to transfer them to the DNC
The PC must b
CYBACK allo
intervention on the data on the PC's level.
Easy, practical and very rapid, this possibility facilitates in case of neces
the updating of the DNC software in the FLASH memory.
The PC must be equipped with the updating software.
DNC <-> PC STATUS TEST
TRANSFER _ 1,2 Cyback
3,4 DATA LINK TEST 1 2
7 FLASH
8 EXT KEYB
11 Internal backup
12 Internal restore
Quantity of free backup memory 96%
-- COMPUTER LINK --
Baud rate 57600 Stop 1.0
Parity odd (1) EVEN (0) _ Bits 8
Who commands ? This page will only be used to initialize the transmission type. It is not
possible to start the transmission from the DNC, this will always be done
TRANSFER Allows to select the type of transmission.
ata transfer between the PC
yback and the DNC. For details, refer to
, CYBACK.
DATA LINK TEST Selects the test mode of the serial ports.
See the following chapter.
DNC to receive an updating.
EXT KEYBD Puts the DNC in external terminal mode.
See the concerned chapter.
Internal backup Launches a backup of all mac
and/or tools onto the Flash m ils,
refer to page 98, Internal Bac
Internal restore Restores all machine paramters and/or tools
previously backed up in the Flash memory. For
details, refer to page 100, Internal restore of
PMs and tools
from the PC.
Cyback Will initialize a d
utility C
page 80
FLASH Prepares the
hine parameters
emory For deta
kup.
.
PAGE 78 USER GUIDE DNC 600S
To Next Page
Loading...
